Application for Syner Gel
Syner Gel has a recommended cure thickness of 0.6mm, this means that each layer should be no more than 0.6mm thick. For reference our AnGel builder gel has a cure thickness of 1mm and Flexi gel 0.3mm.
A a stand alone product (structured manicure)
1. Prep the natural nails using your preferred method (we
recommend using a sanding band or manually using a 180/240 nail file to gently etch the nail surface)
Do not apply any cleaners, dehydrators or acetone to the natural nail after prep as this can over dehydrate the nail and lead to premature lifting of the gel.
2. Apply Xprime OR Primer for maximum adhesion
3. Apply a thin layer of Syner Gel to the natural nail and cure in our Lumi Lamp or Lumi Spark Lamp for 60 seconds.
4. Repeat step 3 but do not cure
5. Apply a thicker layer of the product and float it down the nail, allowing it to self-level and manipulating with a fine liner brush as required.
6. Cure for 60 seconds or on 90 second low heat mode.
7a. Remove the inhibition layer, refining where necessary using a 180 buffer or lightly using a 240 nail file and apply gel polish when happy
with the finish.
7b. Apply gel polish straight on top if there is no refining.
As a base layer before AnGel, Dura Gel or Gel polish
1. Prep the natural nails using your preferred method (we
recommend using a sanding band or manually using a 180/240 nail file to gently etch the nail surface)
Do not apply any cleaners, dehydrators or acetone to the natural nail after prep as this can over dehydrate the nail and lead to premature lifting of the gel.
2. Apply Xprime OR Primer for maximum adhesion
3. Apply a thin layer of Syner Gel to the natural nail and cure in our Lumi Lamp or Lumi Spark Lamp for 60 seconds.
4. Apply gel polish or slip layer of AnGel or Dura Gel and continue with the aforementioned treatment.
